You came to the right place! If you are looking to get your Laser Cut Parts Fast, our team is ready for you. From our wide range of Laser Cutting Capabilities, we are sure to get your parts with the quality, price and lead time required. Please take a moment to go over our Laser Cutting guidelines below:
Laser cutting will leave a sharp edge and cut will have a shiny look with some striations which will vary depending on Material being cut and Assist gas used.
Laser cutting will add heat to your parts
When Laser Cutting Foam and Rubber materials, a powder like finish will be present on the cut surfaces.
If your parts don’t fit this guideline below, feel free to contact us to discuss your project.
Laser Cut Flange From 1/2 Inch Low Carbon Steel
Laser Cutting Part Size
Minimum thickness = 0.005” thick
Maximum thickness = 0.625” thick
Minimum part size = 0.500” x 0.500”
Maximum part size = 59.50” x 119.50”
Aluminum up to 0.25” thick, Brass & Copper up to 0.25’’, Steel up to 1.00” thick & Stainless up to 0.25” thick.
Plastics, Gasket Materials & Rubber
Typical Profile Tolerance is +/-0.010”
Laser Cut Hole Size
Hole Sizes = Minimum hole size is based on the thickness of the material being cut. Its typically a one to one proportion. For example, a 0.125” thick material requires a minimum hole size of 0.125”
Typical Tolerances:
Holes +/-0.005”
Hole Location +/-0.005”
Tighter Tolerances are Achievable
Typical Parts:
Plates
Brackets
Covers
Flanges
Typical Materials:
Aluminum
Steel
CRS
Acrylics
Rubber
Foams